Green Progress
 

Environmental Protection & Preservation


New Aerogels Could Clean Contaminated Water, Purify Hydrogen for Fuel Cells


Scientists at the US Department of Energy's Argonne National Laboratory have identified a new technique for cleansing contaminated water and potentially purifying hydrogen for use in fuel cells, thanks to the discovery of a innovative type of porous material.

Argonne materials scientists Peter Chupas and Mercouri Kanatzidis, along with colleagues at Northwestern and Michigan State universities, created and characterized porous semiconducting aerogels at Argonne's Advanced Photon Source (APS). The researchers then submerged a fraction of a gram of the aerogel in a solution of mercury-contaminated water and found that the gel removed more than 99.99 percent of the heavy metal. The researchers believe that these gels can be used not only for this kind of environmental cleanup but also to remove impurities from hydrogen gas that could damage the catalysts in potential hydrogen fuel cells.

"When people talk about the hydrogen economy, one of the big questions they're asking is 'Can you make hydrogen pure enough that it doesn't poison the catalyst?'" Chupas said. "While there's been a big push for hydrogen storage and a big push to make fuel cells, there has not been nearly as big a push to find out where the clean hydrogen to feed all that will come from."

The aerogels, which are fashioned from chalcogenides - molecules centered on the elements found directly under oxygen in the periodic table - are expected to be able to separate out the impurities from hydrogen gas much as they did the mercury from the water: by acting as a kind of sieve or selectively permeable membrane. The unique chemical and physical structure of the gels will allow researchers to "tune" their pore sizes or composition in order to separate particular poisons from the hydrogen stream.

"You can put in elements that bind the poisons that are in the stream or ones that bind the hydrogen so you let everything else fall through," Chupas said. For example, gels made with open platinum sites would extract carbon monoxide, a common catalyst poison, he explained.

The research team had not intended to create the aerogels, but their discovery proved fortunate, said Kanatzidis. Originally, the researchers had used surfactants to produce porous semiconducting powders instead of gels. When one of the researchers ran the synthesis reaction without the surfactant, he noticed that gels would form time after time. "When we saw that these chalcogenides would make a gel, we were amazed," said Kanatzidis. "We turned the flask upside down and nothing flowed."

Generally, such reactions produce only uninteresting precipitates at the bottom of the flask, he said, so that in this case, "we knew we had something special."

Kanatzidis and his co-workers recognized that aerogels offered one remarkable advantage over powders: because the material maintained its cohesion, it possessed an enormous surface area. One cubic centimeter of the aerogel could have a surface area as large as a football field, according to Kanatzidis. The bigger the surface area of the material, the more efficiently it can bind other molecules, he said.

Previous experiments into molecular filtration had used oxides rather than chalcogenides as their chemical constituents. While oxides tend to be insulators, most chalcogenides are semiconductors, enabling the study of their electrical and optical characteristics. Kanatzidis hopes to examine the photocatalytic properties of these new gels in an effort to determine whether they can assist in the production, and not merely the filtration, of hydrogen.

Unlike periodic materials, which possess a consistent long-range structure, the gels formed by the Northwestern and Argonne researchers are highly disordered. As a result, conventional crystallographic techniques would not have effectively revealed the structure and behavior of the gels. The high-energy X-rays produced by the APS, however, allowed the scientists to take accurate readings of the atomic distances within these disorganized materials. "This is where the APS really excels. It's the only place that has a dedicated facility for doing these kinds of measurements, and it allows you to wash away a lot of old assumptions about what kinds of materials you can and cannot look at," Chupas said.

The paper, entitled "Porous semiconducting gels and aerogels from chalcogenide clusters," appears in the July 27 issue of Science.

The initial research into porous semiconducting surfactants was supported by a grant from the National Science Foundation. Use of the APS was supported by DOE, Office of Science, Office of Basic Energy Sciences.





More Environmental Protection & Preservation Articles


Global Thermostat Named Among World’s 10 Most Innovative Energy Companies


Coal-fired power generation coming to an end in New Zealand


Researchers Find Less Expensive Way to Convert Carbon Dioxide


New Technology to Recycle All Type of Plastics Without Using Water


Recycling Styrofoam into rigid plastic


Veolia transforms non-recyclable paper into new products


SaskPower launches world's first commercial carbon capture and storage process


Carbon Taxes and Emissions Trading are Cheapest Ways of Reducing CO2, According to OECD


Artificial Lung to Remove Carbon Dioxide - from Smokestacks


Pilot Plant to Permanently Store CO2 Emissions as Carbonate Rock Bricks for use in Construction Industry

even more articles...

Suggest an Article for Green Progress









Green Progress :: Green Technology and Environmental Science News
Green Progress is an EcoMethods™ sustainability project. Copyright © 2005 - 2018 Green Progress. All rights reserved.